BMW Spoilers
Buick Spoilers
Cadillac Spoilers
Chevrolet Spoilers
Chrysler Spoilers
Dodge Spoilers
Ford Spoilers
Honda Spoilers
Hyundai Spoilers
Kia Spoilers
Lexus Spoilers
Mazda Spoilers
Nissan Spoilers
Scion Spoilers
Tesla
Toyota Spoilers
Volkswagen Spoilers

 

Acura Moldings
Audi Moldings
BMW Moldings
Buick Moldings
Cadillac Moldings
Chevrolet Moldings
Chrysler Moldings
Dodge Moldings
Ford Moldings
Honda Moldings
Hyundai Moldings
Jeep Moldings
Kia Moldings
Lexus Moldings
Lincoln Moldings
Mazda Moldings
Nissan Moldings
Pontiac Moldings
Saturn Moldings
Scion Moldings
Subaru Moldings
Toyota Moldings
Volkswagen Moldings

 

Tree Topper 14 inch
Tree Topper 18 inch

 

Universal Rear Window Spoiler

 

CHRYSLER DODGE
FORD
GM
HONDA
HYUNDAI
KIA
NISSAN
TOYOTA
VW




Custom Car, Auto, Truck and SUV Spoilers, Body Side
Moldings & Accessories. Buy Securely Online.
 Shopping Cart: 
  now in your cart  0 items 

Basic Installation of Body Side Moldings

LOCATION:  Using masking tape, run the tape from point A (front) to point B (rear).  Press tape against vehicle, making sure that the tape is straight from Point A to Point B.

 

CLEAN AND PREP:  For proper installation of Body Side Molding, clean the surface where the molding is to be installed using rubbing alcohol.  Wipe off excess with a clean cloth.  Where cooler temperatures prevail, make certain the molding and vehicle is at room temperature.  If the surface is cold, use a heat gun to warm before preceeding with installation.

 

INSTALLATION:  Before starting, peel back 12" of the red liner, removing the rest of the liner as you install.  DO NOT TOUCH THE EXPOSED ADHESIVE with your fingers as the installation is being done.  (Note:  excess skin oil will affect adhesion).  

 

 Since these moldings have been pre-cut, start adhering moldings, front and rear the the angle cuts first and the bullet side directed toward the appropriate wheel well adhered last.

 

APPLYING THE MOLDING using the bottom edge of the masking tape as your guide, peel the rest of the liner as you go.

 

AFTER THE MOLDING has been installed, use a soft cloth to apply pressure along the entire length of the molding to insure proper adhesion.  Remove masking tape and you will have an OEM style custom Body Side Molding that will give you many years of protection.

Online Payment System


 
 

 
Home  |   About Us  |   Contact Us  |   Warranty Registration  |   Privacy Policy |   Shipping Policy  |   Return Policy 



Copyright © 2024 - Spoiler and Wing King - All Rights Reserved
Designed & Hosted By OnLine ConneXions Inc.